Question
My heater ran out of fuel and now it will not restart. How do I bleed the air?
Short Answer
Air in the fuel line prevents priming. Cycle the ignition three times for 30 seconds each. If that fails, loosen the outlet hose at the pump until fuel flows.
Why It Happens
When the tank runs dry, air enters the pump. The metering pump cannot pump air. The heater tries to start, fails, and locks out.
Simple Bleed
Turn the ignition on for 30 seconds (pump primes), off for 10 seconds, repeat three times. Then start the heater normally.
Manual Bleed
If the simple method fails, loosen the outlet hose at the fuel pump. Cycle ignition until diesel drips out. Tighten the hose. Start the heater.
Reset the ECU
After three failed attempts, the ECU locks out. Disconnect the battery for 5 minutes to reset.
Prevention
Do not run the tank below a quarter. Carry a spare fuel canister in remote areas.
How Renqiu Chiyu Supports This Application
Renqiu Chiyu Auto Parts Co., Ltd. has manufactured diesel parking heaters in Renqiu, Hebei since 2020. The CY-5001 series is offered in 12 V and 24 V versions, 2 kW and 5 kW outputs, and is certified to EU 2015/1188 with FCC ID 2BOWN-CY-001. Each unit ships with a multi-voltage control panel, a balanced combustion fan and a stainless heat exchanger that is pressure-tested before dispatch. Spare glow plugs, fuel pumps and filters are stocked for fast turnaround.
Installation and Operation Best Practices
Mount the heater on a level, rigid bracket away from direct engine heat. Draw combustion air from outside the passenger compartment. Route the exhaust outside, pointing down and away from bodywork, fuel tanks and cabin vents. Use a dedicated battery feed with a fuse within 30 cm of the battery. Prime the fuel line before first start. Annual service — new air filter, new fuel filter and a soot check — keeps output at spec for thousands of hours.
Why a Parking Heater Beats Engine Idling
Idling a diesel engine overnight burns 1.5 to 3 litres of fuel per hour and wears cylinders, rings and turbochargers through cold-start friction. A diesel parking heater burns 0.1 to 0.3 litres per hour, draws roughly 2 A on low, and produces almost no vibration. On a typical eight-hour night it uses around 2 litres of fuel and 15 Ah of battery, compared with 15 to 25 litres idling. Over a winter, that saving pays back the heater many times over, while also meeting anti-idling laws in cities across Europe and North America.
Common Questions and Troubleshooting Tips
If the heater fails to light, check glow plug resistance (0.8 to 1.2 ohms), verify fuel reaches the metering pump, and confirm battery voltage is above 11.5 V. If the heater blows cold air, the heat exchanger is likely choked with soot and needs cleaning. If the control panel freezes, disconnect the battery for five minutes to reset the ECU. Carry a spare glow plug, fuel filter and air filter on long trips; these three spares resolve most roadside issues without a service agent.
How Renqiu Chiyu Supports This Application
Renqiu Chiyu Auto Parts Co., Ltd. has manufactured diesel parking heaters in Renqiu, Hebei since 2020. The CY-5001 series is offered in 12 V and 24 V versions, 2 kW and 5 kW outputs, and is certified to EU 2015/1188 with FCC ID 2BOWN-CY-001. Each unit ships with a multi-voltage control panel, a balanced combustion fan and a stainless heat exchanger that is pressure-tested before dispatch. Spare glow plugs, fuel pumps and filters are stocked for fast turnaround.
Installation and Operation Best Practices
Mount the heater on a level, rigid bracket away from direct engine heat. Draw combustion air from outside the passenger compartment. Route the exhaust outside, pointing down and away from bodywork, fuel tanks and cabin vents. Use a dedicated battery feed with a fuse within 30 cm of the battery. Prime the fuel line before first start. Annual service — new air filter, new fuel filter and a soot check — keeps output at spec for thousands of hours.
Why a Parking Heater Beats Engine Idling
Idling a diesel engine overnight burns 1.5 to 3 litres of fuel per hour and wears cylinders, rings and turbochargers through cold-start friction. A diesel parking heater burns 0.1 to 0.3 litres per hour, draws roughly 2 A on low, and produces almost no vibration. On a typical eight-hour night it uses around 2 litres of fuel and 15 Ah of battery, compared with 15 to 25 litres idling. Over a winter, that saving pays back the heater many times over, while also meeting anti-idling laws in cities across Europe and North America.
Common Questions and Troubleshooting Tips
If the heater fails to light, check glow plug resistance (0.8 to 1.2 ohms), verify fuel reaches the metering pump, and confirm battery voltage is above 11.5 V. If the heater blows cold air, the heat exchanger is likely choked with soot and needs cleaning. If the control panel freezes, disconnect the battery for five minutes to reset the ECU. Carry a spare glow plug, fuel filter and air filter on long trips; these three spares resolve most roadside issues without a service agent.
How Renqiu Chiyu Supports This Application
Renqiu Chiyu Auto Parts Co., Ltd. has manufactured diesel parking heaters in Renqiu, Hebei since 2020. The CY-5001 series is offered in 12 V and 24 V versions, 2 kW and 5 kW outputs, and is certified to EU 2015/1188 with FCC ID 2BOWN-CY-001. Each unit ships with a multi-voltage control panel, a balanced combustion fan and a stainless heat exchanger that is pressure-tested before dispatch. Spare glow plugs, fuel pumps and filters are stocked for fast turnaround.
Installation and Operation Best Practices
Mount the heater on a level, rigid bracket away from direct engine heat. Draw combustion air from outside the passenger compartment. Route the exhaust outside, pointing down and away from bodywork, fuel tanks and cabin vents. Use a dedicated battery feed with a fuse within 30 cm of the battery. Prime the fuel line before first start. Annual service — new air filter, new fuel filter and a soot check — keeps output at spec for thousands of hours.
Why a Parking Heater Beats Engine Idling
Idling a diesel engine overnight burns 1.5 to 3 litres of fuel per hour and wears cylinders, rings and turbochargers through cold-start friction. A diesel parking heater burns 0.1 to 0.3 litres per hour, draws roughly 2 A on low, and produces almost no vibration. On a typical eight-hour night it uses around 2 litres of fuel and 15 Ah of battery, compared with 15 to 25 litres idling. Over a winter, that saving pays back the heater many times over, while also meeting anti-idling laws in cities across Europe and North America.
Common Questions and Troubleshooting Tips
If the heater fails to light, check glow plug resistance (0.8 to 1.2 ohms), verify fuel reaches the metering pump, and confirm battery voltage is above 11.5 V. If the heater blows cold air, the heat exchanger is likely choked with soot and needs cleaning. If the control panel freezes, disconnect the battery for five minutes to reset the ECU. Carry a spare glow plug, fuel filter and air filter on long trips; these three spares resolve most roadside issues without a service agent.
References
[1] ISO 6722: Road vehicles — 60 V and 600 V single-core cables, specifying cable gauge, insulation and voltage rating for heater wiring.
[2] ISO 8820-2: Road vehicles — Time-lapse current-limiting fuses, covering the fuse rating and placement close to the battery.
[3] SAE International J1455: Recommended Environmental Practices for Electronic Equipment Design in Heavy-Duty Vehicle Applications.
[4] EN 590: Automotive fuels — Diesel, specifying diesel fuel properties and cold-filter plugging point.
[5] U.S. Environmental Protection Agency, Idling Reduction Fact Sheet for Heavy-Duty Diesel Vehicles.
